Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Before
After
Before
After
Before
AfterECO Window Systems Roof Replacement & Installation in Gladeview: What to Know First
ECO Window Systems roof replacement and installation in Gladeview typically runs between $8,500 and $22,000 depending on roof size, material, and the condition of the existing deck. As an independent ECO Window Systems service provider, Winslow Windows & Doors handles full roof replacement and installation for Gladeview homeowners whose ECO Window Systems windows, doors, and exterior systems need a roof that actually protects them. Most residential replacements take 3 to 7 working days once materials are on site. This page is for Gladeview homeowners who want straight answers on cost, process, and what can go wrong if the roof goes on wrong. Call (727) 604-9322 for a free estimate. Ed Winslow answers the phone.
Key Takeaways
- We replace and install roofs in Gladeview while working around existing ECO Window Systems windows and doors, including impact-rated units.
- Typical residential roof replacement in Gladeview costs $8,500 to $22,000. We give written line-item quotes, not round numbers.
- We are an independent provider. We are not authorized by or affiliated with ECO Window Systems. We install their products, we service them, and we tell you the truth about both.
- Every roof job includes the Done Right Promise. If it’s not done right, we come back and make it right.
How ECO Window Systems Products Fail - and How We Fix Them
Roof replacement in Gladeview is not just about shingles and flashing. The roof has to tie into the windows, doors, and exterior openings already in the home. When an ECO Window Systems product is in the mix, the failure points are usually where the roof meets the opening, or where water has been getting past the flashing long enough to rot the substrate. Here are the failures we see most often in Gladeview.
- ECO 700 Series single-hung units pulling water at the head. The 700 Series is a workhorse in Gladeview’s older concrete-block homes, but the head flashing detail is unforgiving. If the roof underlayment was cut short around a second-story window, wind-driven rain wicks behind the top flange and shows up as a water stain on the interior drywall six months later. Our fix is to strip the roof edge, install a full width of peel-and-stick membrane over the window head, and reflash before the new roofing goes down.
- Impact casement and fixed units on gable walls popping drywall seams after roof work. The ECO Window Systems impact casement lines are heavy. If a roofer tears off the old roof and the deck is soft near a gable-end window, the wall shifts a fraction of an inch and the casement loses its square. Then the sash drags or the seal fails. We sister new framing at the rough opening before we ever lay the new roof.
- Roof-to-wall transitions leaking around ECO fixed picture windows in mid-century Gladeview ranchers. Gladeview has a lot of low-slope or nearly flat roof sections. On an older ranch with a fixed picture window tight against a parapet wall, the old counterflashing was often just tar smeared over the seam. Florida sun bakes it until it cracks, and water follows the crack straight into the window head. We install proper two-piece counterflashing and reglet, then seal with a polyurethane that moves with the building.
- Condensation inside ECO sliding glass doors after a new roof raises attic heat. If the roof was replaced with a darker material or ventilation was blocked, the attic runs hotter. That heat pushes through the wall and hits the cool glass on an ECO sliding door, and suddenly the homeowner has condensation between the panes. A proper ridge vent and balanced intake fixes it. We check the roof ventilation as part of every Gladeview replacement.
- OEM flashing kits that were never installed right in the first place. ECO Window Systems ships good flashing with their products. The problem is that a previous crew skipped it. We reuse or replace OEM flashing components and then add our own membrane layering, because in Gladeview the afternoon thunderstorms will find any gap you leave.
Our ECO Window Systems Roof Replacement & Installation Process
Here’s how a typical Gladeview roof replacement goes when we’re working around ECO Window Systems windows and doors.
- 1
We walk the roof and every exterior opening. Before we touch a shingle, we check how the existing roof ties into each ECO Window Systems unit. We look for rusted flashing, soft decking, and gaps at the window heads.
- 2
We write a line-item quote. You see the price for tear-off, deck repair, underlayment, roofing material, flashing, and cleanup. No lump sum, no “we’ll see when we get up there.”
- 3
We pull permits. Gladeview requires a permit for roof replacement. We pull it, schedule inspections, and make sure the job passes.
- 4
We protect the windows and doors. Tear-off debris destroys glass and frames. We cover every ECO Window Systems unit within 20 feet of the work area with plywood and padded blankets before the first shingle comes off.
- 5
We install the roof, then reflash every opening. New decking where needed, synthetic underlayment, the roofing material you chose, and then we reflash around every window, door, and penetration with new metal and sealant.
- 6
We walk the job with you and clean the site. Magnets for nails, blowers for the walkways, and a final check of every ECO Window Systems opening. Then Ed hands you the warranty paperwork.
What ECO Window Systems Roof Replacement & Installation Costs in Gladeview
Here’s the honest math. Most Gladeview homes with ECO Window Systems products fall into these ranges.
- Asphalt shingle roof on a standard Gladeview ranch, 1,400 to 1,800 sq. ft: $8,500 to $12,500
- Asphalt shingle roof on a two-story, 2,000 to 2,600 sq. ft: $11,500 to $16,500
- Roof with tile or standing seam metal replacement: $18,000 to $32,000 and up, depends on material and roof complexity
- Full roof deck replacement due to rot or termite damage: Adds $2,500 to $6,000 depending on how much of the deck is gone
What moves the price in Gladeview? The roof slope, the number of ECO Window Systems units we have to reflash, the condition of the deck, and whether the home is in a mapped wind zone that requires additional fastening. A two-story runs more because of staging and safety. We never pad the quote. Call (727) 604-9322 and we’ll give you an exact number in writing. Free estimate.
Why Gladeview Homeowners Call Winslow Windows & Doors for ECO Window Systems Work
Ed Winslow grew up in Gladeview and still lives a few miles from the Palmetto Expressway corridor he drove past every morning on the way to school. He took building construction technology at Miami Dade College and has been fitting windows and doors in this area for over two decades. His name is on the truck, and the work has to match it. We’ve been in business since 2011, locally owned and owner-operated. We are authorized installers for eight brands: ECO Window Systems, PGT, CGI, CWS, ES Windows, Mr-Glass, Therma-Tru. If an ECO Window Systems part is backordered, we can cross-reference what’s available from PGT or CGI and tell you honestly whether it’s a fit. Every technician is background-checked and uniformed. A live person answers the phone 24/7. And every job carries the Done Right Promise. If it’s not right, we come back.
FAQs
It can, and this is where we earn our keep. ECO Window Systems warranties generally require that the flashing and rough opening remain intact and that roof work not compromise the installation. If a roofer damages the flange or leaves the opening exposed to water, the manufacturer can deny a future claim because the failure would be considered installation-related. We reflash every opening to the manufacturer’s detail and document the work. Your warranty stays intact because we do the roof the way the window needs it done. Call (727) 604-9322 for a free estimate and we’ll walk you through exactly what we protect and how.
Most Gladeview homes are done in 3 to 7 working days once materials arrive. Permitting in Gladeview can add a week or two depending on the municipality’s review schedule. We don’t rush the flashing work around your windows because that’s where the leaks start. Call (727) 604-9322 and we’ll give you a realistic timeline for your street.
Yes. We order flashing and trim in finishes that match common ECO Window Systems frame colors, and when an exact OEM part is no longer available we fabricate a match from a local Gladeview metal shop. The seal is what matters most. The color we can match. Call (727) 604-9322 and we’ll come take a look at what you have.
Then the roof or the flashing above it is usually the root cause, not the window itself. We trace the water path from the roof plane to the opening, repair the roof or flashing, and only then determine whether the window itself needs service. We don’t replace a good ECO Window Systems unit to fix a flashing problem. Call (727) 604-9322 and we’ll find the actual source. Estimates are free.
Yes. If you already have a written estimate from another Gladeview roofing company, we’ll review it, walk your roof, and tell you what’s right, what’s missing, and what you should not pay for. That second opinion is free. Call (727) 604-9322 and schedule it.
Written by Ed Winslow, Owner, Winslow Windows & Doors, serving Gladeview and nearby areas.
Six Reasons Homeowners Choose Winslow Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.